Toilet Tank Installation Guide

In this guide we will go step by step through the correct installation of a toilet tank. Following these simple steps will ensure a successful installation.

Materials Needed:

• Toilet tank
• Fastening screws
• Screw thread
• Internal tank mechanism
• Jointing rubber

Steps:

Step 1: Preparing the Toilet Bowl

Place the threads of the fixing screws into the corresponding holes in the toilet bowl. Make sure they are tightened securely.

Step 2: Installing the Mechanism on the Tank

Place the internal mechanism in the tank according to the manufacturer's instructions. Be sure to follow the directions for proper installation.

Step 3: Positioning of the Rubber Band

Place the rubber gasket in its corresponding position on the bottom of the tank. Make sure it is evenly positioned to ensure an efficient seal.

Step 4: Placing the Tank in the Cup

Lift the tank and place it over the toilet bowl, aligning the threaded holes with the previously installed set screws.

Step 5: Adjusting the Screws

Start tightening the set screws gradually and alternately. This means tightening one screw a little and then moving on to the next, repeating the process until both are tight.

Be sure to tighten the screws evenly to ensure that the tank is perfectly vertical.

Step 6: Verification of the Adjustment

Once the screws are tightened securely, check that the tank is level and firmly attached to the toilet bowl. Adjust as necessary.

Step 7: Performance Test

Fill the tank with water and perform a flush test to ensure that the mechanism is working properly and that there are no leaks at the connection between the tank and the bowl.

By following these steps, you will have properly installed your toilet tank. Remember to always refer to the manufacturer's specific instructions to ensure proper installation and avoid future problems. Ready to enjoy a perfectly functioning toilet!